When Nozzle Clogging Cannot Be Solved
4-17
1
1
1
4
Routine Maintenance
Alternative nozzles for printing, when nozzles missing can not be improved
NOZZLE RECOVERY: When nozzles missing can not be improved at specific points, other good nozzles can
be used as alternatives for printing.
The head of this machine consists as the right figure.
You can set the recovery by specifying the nozzle line
each for the H1-2 (Head 1-2), the H3-4 (Head 3-4) and the
H5-6 (Head 5-6).
1
Select [NOZZLE RECOVERY] of the maintenance menu.
(1) Press the key in LOCAL.
(2) Press to select [MAINTENANCE] and press the key.
(3) Press to select [NOZZLE RECOVERY].
(4) Press the key.
2
Press to select [PRINT] and press the
key.
3
Press to select the head (H1-2/ H3-4/ H5-6)
for which you perform nozzle recovery.
4
Press the key twice.
• The nozzle pattern of selected unit is printed.
• When you select “ENTRY” in the Step 2, the machine moves to the
nozzle line selection procedures (Step 5) without printing a nozzle
pattern.
About nozzle line
• This machine is equipped
with four nozzle lines (Line
A, Line B, Line C and Line
D) for one head.
To Next Page
Loading...
