MIMAKI JFX500-2131 - Setting MAPS2 Function (4 Color + Special Color Ink)

3-22
12
Press to change the smoothing level.
• Set Value : AUTO, 5 to 100% (set in units of 5%)
AUTO : Set the smoothing level automatically depending on printing mode.
5 to 100% :
The MAPS2 effect become strong as the set value increase, and become weak as the set value
decrease.
13
Press the key.
14
Press the key several times to end the setting.
Setting MAPS2 Function (4color + special color ink)
1
Press the key in LOCAL.
2
Press to select [SET UP].
3
Press the key.
4
Press to select [MAPS].
5
Press the key.
6
Press to select “MAPS2” and press the
key.
•Set Value：MAPS1, MAPS2, OFF
• If you selected OFF, proceed to step 11.
7
Press to select “AUTO” or “MANUAL”.
AUTO : Set the print pattern and smoothing level to the
recommended value automatically depending on printing mode.
MANUAL : You can adjust the set value.
• If feeding stripes and color change is not improved by “AUTO” setting, please adjust the
print pattern and smoothing level by “MANUAL” setting.
MAPS 2
SMOOTHING LV. : 100%
SETUP
MAPS [ EN T ]
FUNCT I ON
VIEW [ENT]
FUNCT I ON
SETUP [ ENT ]
SETUP
FEED COMP . [ ENT ]
SETUP
MAPS [ EN T ]
MAPS
:OFF
MAPS 2
:AUTO
MAPS 2
:AUTO