MIMAKI JFX500-2131 - Page 69

3-23
1
1
3
Convenient use
5
6
Perform setting to reduce stripes between passes
8
Press the key.
• When selecting the “AUTO” in the Step 6, proceed to the step 11.
• When selecting the “MANUAL” in the Step 6, proceed to the step8.
9
Press and select pattern and
color to be printed.
：Select the Pattern1 to Pattern 5.
：Select color(COLOR or SPOT(special color))
10
Press the key.
11
Press to change the smoothing level and
color.
Set Value : AUTO, 5 to 100% (set in units of 5%)
AUTO : Set the smoothing level automatically depending on printing mode.
5 to 100% :
The MAPS2 effect become strong as the set value increase, and become weak as the set value
decrease.
• ：Select the smoothing level.
• ：Select color (COLOR or SPOT(special color))
12
Press the key.
13
Press the key several times to end the setting.
• MAPS2 effect differs depending on image to be printed. Change the printing pattern and
use it after checking effect in advance.
COLOR >
PATTERN : 1
<SPOTR
PATTERN : 2
<SPOTR
SMOOTH I NG L V . : AUTO
<SPOTR
SMOOTH I NG L V . : 1 0 0%
SETUP
MAPS [ EN T ]