MIMAKI JFX500-2131 - Washing of Head Nozzle; When Nozzle Clogging Cannot be Solved

When Nozzle Clogging Cannot Be Solved
4-15
1
1
1
4
Routine Maintenance
Washing of Head nozzle
Perform cleaning of the nozzles in the heads to prevent them being clogged with coagulated ink.
1
Press the key in LOCAL.
2
Press to select [NOZZLE WASH].
3
Press the key.
• The carriage moves onto the table.
4
Clean the wiper and the bracket.
(1) Pull out it by holding projections at both ends of the wiper.
(2) Clean the wiper and bracket with a clean stick dipped in cleaning solution for maintenance.
(SPC-0568) Wipe off so that cleaning solution for maintenance will not remain.
(3) Insert it in the original position by holding the projections at both ends of the wiper.
5
Press the key.
Check the items on the
right beforehand.
Is [INK END] displayed?
• The ink is absorbed when the nozzles are washed.
At this time, if the state of "INK END" is detected, the nozzle washing operation
cannot start.
• Add ink in the ink bottle of the external ink supply unit.
• While working, be careful to avoid subjecting the capping station to direction sunlight. Ultraviolet light
will cure UV ink. Take measures to block sunlight, such as closing the curtains on windows.
• Until wiper cleaning is competed, [COMPLETED (NEXT): ENT] is displayed on the screen. After
the work up to the step 4 is completed, press the key. If you press the key
before cleaning is completed, the machine moves to the next washing procedure.
• Until wiper cleaning is competed, [COMPLETED (NEXT): ENT] is displayed on the screen. After
the work up to the step 6 is completed, press the key. If you press the key
before cleaning is completed, the machine moves to the next washing procedure.
CARR I AGE OUT
[ENT]
MAINT.
NOZ Z L E WASH
[ENT]
WI PER CLEAN I NG
COMP L ETED ( NEX T ) [ ENT ]
Projection
CAP CLEAN I NG
COMP L ETED ( NEX T ) [ ENT ]