MIMAKI JFX500-2131 - Setting a Media

2-5
1
2
Basic Operations
4
5
6
Setting a Media
This machine can be used with a leaf media.
For usable medias, refer to P.1-15 “Usable sizes of media”.
Setting the Media
1
Switch over the suction valve at the right side of
the table adjusting with the size of the media to
be set.
• The valve is opened when the knob is turned vertically and
closed when it is turned horizontally.
2
Press the key to light the “VACUUM” lamp and vacuum the media.
• As for the details of the absorption area, please refer to P.2-6.
• If, within the absorption area, there are suction holes not closed by the media, close such suction
holes placing thin sheet form material such as paper, film or tape.
• The peripheral parts of the media could roll up due to heat. Fix the media supplementarily using
adhesive tapes, etc.
• There are guide holes into which the attached positioning pin is inserted at the edge of the table (two
sides of upper and lower of the table). Use them as the guides for setting the media straight.
( P.2-7 )
After setting the media, set the followings.
• Register the thickness of the set media. ( P.3-4)
• Register the head gap. ( P.3-6)
Open Close
Suction valve
Absorption area