MIMAKI JFX500-2131 - Setting MAPS2 Function (4 Color)

3-21
1
1
3
Convenient use
5
6
Perform setting to reduce stripes between passes
Setting MAPS2 Function (4 color)
1
Press the key in LOCAL.
2
Press to select [SET UP].
3
Press the key.
4
Press to select [MAPS].
5
Press the key.
6
Press to select MAPS2.
•Set Value：MAPS1, MAPS2, OFF
7
Press the key.
• If you selected OFF in step 5, proceed to step 12.
8
Press to select “AUTO” or “MANUAL”.
• AUTO:Set the print pattern and smoothing level to the recommended
value automatically depending on printing mode.
• MANUAL:You can adjust the set value.
9
Press the key.
• When selecting the “AUTO” in the Step 7, proceed to the step 12.
• When selecting the “MANUAL” in the Step 7, proceed to the step 9.
10
Press to select pattern to print.
• Set value：Pattern1 to Pattern 5
11
Press the key.
• If feeding stripes and color change is not improved by “AUTO” setting, please adjust the
print pattern and smoothing level by “MANUAL” setting.
• MAPS2 effect differs depending on image to be printed. Change the printing pattern and
use it after checking effect in advance.
FUNCT I ON
VIEW [ENT]
FUNCT I ON
SETUP [ ENT ]
SETUP
FEED COMP . [ ENT ]
SETUP
MAPS [ EN T ]
MAPS
:OFF
MAPS
:MAPS 2
MAPS 2
:AUTO
MAPS 2
:AUTO
MAPS 2
PATTERN : 1
MAPS 2
PATTERN : 2
MAPS 2
SMOOTH I NG L V . : AUTO