3-26
Setting Ink Heater
Set the time until the head heater and ink heater change to standby status after the print is finished.
(In standby status, the heaters' temperatures decrease and they go on standby.)
1
Press the key in LOCAL.
2
Press to select [SET UP].
3
Press the key.
4
Press to select [INK HEATER].
5
Press the key.
6
Press to select setting time.
•Set Value：NONE, 0 to 60 min
• If you set "NONE", the heaters do not change to standby status.
7
Press the key.
8
Press the key several times to end the setting.
To Next Page
Loading...
