MIMAKI JFX500-2131 - Check the Irradiation Position of the LED UV Lamp

2-8
Check the irradiation position of the LED UV lamp
When printing with this machine, you can move the position of the LED UV lamps before printing.
This machine provides three printing methods:
 Single-layer printing: printing color ink layer on media
 Two-layers printing: printing white ink layer on color ink layer
 Two-layers printing: printing color ink layer on white ink layer
Best-suited position of LED UV lamp
This machine is equipped with four LED UV lamps around the head unit as below.
Move the LED UV lamp.
• The recommended positions for the LED UV lamps are as follows.
Inside curing lamp : Move the inside curing lamp for right and left to the position of 30mm far from
the gauge.
Outside curing lamp : Move the outside curing lamp for right and left to the position of 80mm far from
the gauge.
outside curing
lamp for left
inside curing
lamp for left
inside curing lamp
for right
outside curing
lamp for right
At the front side
At the rear side
Head Unit