1-12
Fill ink
Perform as follows when [INK END] or [INK NEAR END] is displayed on the display.
When [INK END] is displayed
1
Insert the IC chip.
2
Remove the cover of ink bottle to be filled with and
remove it.
3
Check the up/ down movement of the float.
• If there is an abnormality on the float movement because dry ink
adhered to it etc., perform the following procedures:
(1) Place a few drops of washing liquid on the upper part
of the float.
(2) Move the float up/ down to spread washing liquid
evenly.
(3) When the float comes to move smoothly, wipe
washing liquid adhering to the float and the pipe with a
waste cloth etc.
• Move the float up/ down again and check that there is
no abnormality.
• When replacing the ink bottle, ink may spatter. Be careful
not to get ink into your eyes.
• Before replacing the ink bottle, cover around it with a
waste cloth etc. Ink may drop from the float part and may
stain around the part.
To Next Page
Loading...
