Setting ink bottles
1-11
1
Before Use
3
4
5
6
4
Take out the 1 liter ink bottle, and slowly shake it twenty times and more.
• To prevent ink from leaking when you shake it, wear gloves and cover the ink bottle cap with a paper
towel etc. Being in that status, slowly shake it twenty times and more by flowing ink.
5
Remove the lid of the ink bottle to set on the
external ink supply unit.
6
Pour ink in the 1 liter ink bottle into the ink bottle
of the external supply unit.
• Depending on the ink type, aluminum sheet adheres to the
bottle top surface. In such a case, remove it with a cutter.
7
Set the external ink bottle on the bottle holder, and
attach the ink cover.
• Make the nozzle (stick shape) for absorbing ink and the
float sensor for detecting remaining amount of ink so that
they may be in the ink bottle.
• If the ink tray got dirty with ink etc., wipe it off with a waste
cloth etc.
• Before shaking it, check that the cap is firmly closed.
• If you shake it too strong, it may cause ink leakage. Therefore, perform this carefully.
• If the remaining amount of ink is less, ink in the bottle cannot be beaten enough. Tilt the
ink bottle until it becomes vertical.
• Be sure to fill 1 liter ink each time. As ink
information of 1 liter ink has been written in the
IC chip attached with the 1 liter ink bottle, the
machine cannot manage ink if you fill 2 liter ink
at a time.
To Next Page
Loading...
