MIMAKI JFX500-2131 - Page 121

Troubleshooting
5-7
1
1
1
1
5
Troubleshooting
6
Fix the jig on the wiper part and open the ink port
valve at the side you selected in the Step 3.
7
Set the air purge jig to the ink port valve.
8
Discharge ink or purge air from inkport.
• When you press the key, ink is discharged from the
port for a certain period of time.
• When discharging has been completed, “REMOVE THE TOOL” is
displayed on the screen. Do not remove the jig until the message
is displayed.
9
Remove the jig from the ink port and close the ink port
valve.
10
Press the key.
• Supply ink for the subtank with less ink. Wait for a while until the
display changes.
11
If performing an air purge for another ink port, press then perform steps 5 to
10.
• Press to move the cartridge to the capping position.
• Do not open the port valve at the side you did
not select in the Step 3. If you open the valve,
air is mixed from here.
• When the valve is hard to open, use the
attached longnose pliers and open.
Port1
Port2
Insert the jig into the
wiper part and fix it.
Port2
Jig
Port1
AIR PG
START [ ENT ]
REMOVE THE TOOL
COMP L ETED [ ENT ]
* * F I L L UP / SUBTANK * *
PLEASE WA I T
AIR PG
END < > RETRY