MIMAKI JFX500-2131 - Page 55

3-9
1
1
3
Convenient use
5
6
Set the feeding amount of the Y bar
6
Press the key.
• Print a correction pattern again and check it.
• When media correction is needed, perform the operation in Step 5
to make correction.
7
Press the key several times to end the setting.
Performing the station maintenance without key
You can select “FEED COMP.” by using the key in the Local without pressing the key.
Press the
key in Local.
Press to
select [SETUP].
Press the key twice.
• The screen in the Step 3 is displayed. Perform
the procedures from the Step 4.
FEED COMP .
PR I NT [ ENT ]