3-37
Effective Plotting Area
Effective Plotting Area
The printer has an area where printing is not permitted, for mechanical reasons.
This area is called “non-printing area”.
*1 When [DIRECT] has been selected as FEED METHOD, a maximum of 127 mm is added.
Margin
This function adjusts the right and left margins of the media.
Use this function when margines other than 15 mm, which is the standard margin, are required.
Each of the right and left margins of the media can be set independently. (-10 to 85 mm)
The initial value of the right and left non-printing area of media is 15 mm each.
The effective printing area can be changed by changing the non-printing area.
Set the non-printing area using [MARGIN] in FUNCTION mode.
Roll media
15 mm 15 mm
Cut sheet media
Effective
printing area
200 mm
Media feeding
direction
0 mm
15 mm 15 mm
Effective
printing area
150 mm150 mm *1
To Next Page
Loading...
Need help?
General