MIMAKI JV5-160S - CHAPTER 3 Printing

Operation flow ........................................................................3-2
Turning the power on .............................................................3-3
Adjusting the head gap ..........................................................3-5
Setting the media on the printer .............................................3-7
Selecting and checking printing conditions ..........................3-20
Operating the heaters ..........................................................3-21
Setting the reference value for dot misalignment correction 3-26
Checking for nozzle clogging, and unclogging nozzles .......3-28
Correcting the media feed rate [MEDIA COMP.] .................3-33
If dots are not in alignment [DROP.POScorrect] ..................3-35
Effective Plotting Area ..........................................................3-37
Establishing the Origin .........................................................3-38
Printing an image .................................................................3-39
Display of [INK NEAR END] or [INK END] ...........................3-48
Turning the power off ...........................................................3-51
This chapter describes a series of operations and settings, ranging from power-on to
end of printing.
CHAPTER 3
Printing