6-19
Invoking MACHINE SETUP functions
MEDIA CUT
Set whether to allocate [] key to direct key of media cut.
Set Value: [ON, OFF]
When allocated to direct key, media cut is selected with [] key in the local mode, and when it is exe-
cuted, feeding is performed automatically until the printed image passes the cut line and then automatically
cut.
Further, while ON is selected, it is possible to set the [MOVE. DROP MEDIA] with [FUNCTION] key.
[MOVE. DROP MEDIA] is the movement to drop the media stuck on the platen after cutting (feed a
certain quantity and return). When the set value turned to OFF, this movement will not be performed.
Set Value: [ON, OFF]
TIME SET
Set the date and time on the printer.
A past date and time up to 8 o’clock can be input.
If you have set a time in the future by mistake, the setting value can be returned to the previous setting
value by pressing the [FUNCTION] key. However, it is only the last previous setting value that the setting
made by mistake can be returned to.
The actually indicated last previous setting time is the last previous setting value plus the actually elapsed
time.
UNIT SETUP
Set the units of measure to be used with the printer.
Temperature
Set the unit of temperature.
Available setting values: [° C ( Centigrade) , ° F ( Fahrenheit) ]
Length
Select the unit system for the units of length and area.
Available setting values: [mm , inch]
Unit system Units
Millimetre mm m m²
Inch inch , mil ft ft²
To Next Page
Loading...
