MIMAKI JV5-160S - List of Functions

6-3
Invoking SET UP functions
List of functions
This section describes briefly the setup functions and their setting values.
Settings of the setup functions
The operation described below on the operation panel is required to execute the setup functions.
STEPS:
1Make sure that the printer is in LOCAL mode, and then select [SET UP] using the
[FUNCTION] key and press the [ENTER] key.
If it is in REMOTE mode, press the [REMOTE] key.
2Select an appropriate one of Type 1 to Type 4 by means of [] or [], and press the
[ENTER] key.
Set the printing conditions.
3Select a setup function and make setting.
Name Function Refer to
MEDIA COMP. Corrects the feed rate of media p. 6-4
MediaFeed SETUP Set particulars related to media feed. p. 6-4
HEATER Sets heater conditions p. 6-4
PRINT MODE Sets a print quality level and printing direction p. 6-5
INK LAYERS Sets the number of layers in which ink is to be applied p. 6-7
DRYING TIME Sets the time to wait for ink drying p. 6-7
AUTO CUT Cuts the media automatically after printing p. 6-8
PRE-FEED Feeds the media back and forth before printing p. 6-8
MARGIN Sets a non-printing area along the right and left edges of the media p. 6-8
COLOR PATTERN Prints a color pattern on the right edge of the media to check nozzle missing p. 6-8
REFRESH Refreshes the print heads during printing p. 6-9
VACUUM Sets the absorbability of the media. p. 6-9
PRIORITY Sets the priority of settings (host / panel) p. 6-9
AUTO CLEANING Cleans the print heads automatically every completion of printing p. 6-9
Print. MAINTE
*1
*1. Only when dedicated sublimation transfer ink Sb51 is used, [Print. MAINTE.] can be set.
Automatically cleans or wipes the heads regularly while printing.
p. 6-10
HEAD GAP Sets the head gap (height from the media to the nozzle plane of the heads). p. 6-10
MEDIA DETECT Sets the method for detecting the media p. 6-10
SETUP RESET
*2
*2. Each item excluding [SETUP RESET] can be registered on the type.
Resets the setting values to the default values
p. 6-10
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
FUNCTION
SET UP <ENT>
SET UP
SELECT : TYPE 1
SET UP
SELECT : TYPE 2