3 Printing
3-18
Setting cut sheet media on the printer
Unlike roll media, cut sheet media need not be retained with the roll holders.
STEPS:
1Open the front cover and raise the clamp lever.
2Insert the cut sheet media between the platen and the pinch rollers.
3Hold the media with the media press lightly, not to be lifted the media.
Take care not to set cut sheet media skew.
Make setting so that the suction hole at the right end of the platen is covered
with the right end of the madia, and adjust the position of the roll holder.
Pinch roller
Platen
Rightmost pinch roller
Suction hole
Media press
Media end
To Next Page
Loading...
