MIMAKI JV5-160S - How to Check the Head Gap

3 Printing
3-6
How to check the head gap
Check the head gap by the following procedure.
STEPS:
1Make sure that the printer is in LOCAL mode.
If it is in REMOTE mode, press the [REMOTE] key.
2Press the [ENTER] key twice.
The information of the current head status is displayed.
3Press the [END] key.
The printer returns to LOCAL mode.
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
HEAD GAP 2.0 mm
MEDIA THICK 0.3 mm
Twice
MEDIA WIDTH 1000mm
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm