MIMAKI JV5-160S - Other Maintenance Functions

4-39
Other maintenance functions
Other maintenance functions
Changing warning time of wiper replacement [WIPER LEVEL]
The wiper is consumable. The heads are easily soiled in a dusty environment.
The heads cannot be cleaned adequately with a curled or worn wiper. This printer gives the wiper replace-
ment warning earlier than standard depending on the operating environment.
Examples of defective wiper
STEPS:
1Make sure that the printer is in LOCAL mode, and then select [MAINTENANCE] using
the [FUNCTION] key and press the [ENTER] key.
If it is in REMOTE mode, press the [REMOTE] key.
2Select [WIPER LEVEL] by pressing the [] key seven times and press the [ENTER]
key.
10/10 Displays the wiper replacement warning when wiping has been performed the standard number of times.
(Initial value)
9/10 Displays the wiper replacement warning when wiping has been performed nine tenths of the standard
number of times.
8/10 Displays the wiper replacement warning when wiping has been performed eight tenths of the standard
number of times.
1/10 Displays the wiper replacement warning when wiping has been performed one tenth of the standard
number of times.
Available setting values of time for warning of wiper replacement
Soiled wiper Curled wiper
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
FUNCTION
MAINTENANCE <ENT>
MAINTENANCE
ST.MAINTENANCE <ent>
MAINTENANCE
WIPER LEVEL <ent>
7
times