MIMAKI JV5-160S - If Image Quality Is Poor; White Lines; Blur (Sprayed Ink); Dark Stripes; Characters Are Double- or Triple-Printed in the Media Feed Direction

5 In Case of Trouble
5-4
If image quality is poor
This section describes the corrective actions to be taken in case the image quality is not satisfactory. Take rem-
edy for particular problems with image quality. If the remedy does not work, contact your dealer or an office
of MIMAKI.
White lines / blur (sprayed ink) / dark stripes
(in the moving direction of the heads)
Remedy
1. Execute the head cleaning.(Refer to “If the printed pattern is abnormal (Cleaning) (p.3-29)” )
2. Perform maintenance of the inside of the station.
(Refer to “Cleaning the wiper and ink caps [CARRIAGE OUT] (p.4-7)” )
3. Execute the [FEED COMP.] function.
(Refer to “Correcting the media feed rate [MEDIA COMP.] (p.3-33)” )
4. Remove pieces of paper or the like, if any, from the path of the heads, for example, above the media
plate.
5. Lessen the head gap, and check printing.
(Refer to “Adjusting the head gap (p.3-5)” )
Characters are double- or triple-printed in the media feed direction
Remedy
Execute the [FEED COMP.] function.
(Refer to “Correcting the media feed rate [MEDIA COMP.] (p.3-33)” )