4 Daily Maintenance
4-30
Preventing nozzle clogging while power is off [SLEEP SET UP]
Even while the power switch is off, the printer starts periodically and executes various functions to prevent
nozzle clogging. [SLEEP SET UP] includes the following functions.
Refreshing interval during sleep mode [REFERSH]
Set the interval at which the nozzles will eject a little volume of ink to prevent nozzle clogging.
STEPS:
1Make sure that the printer is in LOCAL mode, and then select [MAINTENANCE] using
the [FUNCTION] key and press the [ENTER] key.
If it is in REMOTE mode, press the [REMOTE] key.
2Select [SLEEP SET UP] by pressing the [] key five times and press the [ENTER] key.
3Press the [ENTER] key, set the interval time using the [] or [] key, and press the
[ENTER] key.
Input range: OFF, 1 to 168
4Press the [END] key several times.
The printer returns to LOCAL mode.
REFRESH Set the interval at which refreshing operation is to be performed periodically.
TUBE WASH Set the interval at which cleaning of the pump tubes is to be performed periodically.
CLEANING Set the cleaning type and the interval at which cleaning operation is to be performed periodically.
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
FUNCTION
MAINTENANCE <ENT>
MAINTENANCE
ST.MAINTENANCE <ent>
MAINTENANCE
SLEEP SET UP <ent>
Press
5 times
Refresh interval in
the sleep is set up.
SLEEP SET UP
REFRESH <ent>
SLEEP SET UP
REFERSHinterval = 1h
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
To Next Page
Loading...
