MIMAKI JV5-160S - Functions Related to the Cutter

6 Operation for Functions
6-34
Functions related to the cutter
When the media is to be cut at a desired position
Cut the media at any desired position without using the [AUTO CUT] function.
(Refer to “Cutting the media after completion of printing (p.3-41)” )
When [] key is allocated to direct cut key
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
Move the carriage and media using JOG keys so that the carriage
is located at the position where cutting is to be started.
MEDIA CUT <ENT>
ORIGIN SET UP
MEDIA CUTTING PLEASE WAIT
The media is cut.
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
When [HEAD GAP] has been set to 4.1 mm or more, media cut-
ting cannot be performed.
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
MEDIA CUTTING PLEASE WAIT
The media is cut.
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
Movement of the media can not be made.
Cutting can not be made when the [HEADGAP] is 4.1 mm or above.
MEDIA CUT <ENT>