4-7
Cleaning the wiper and ink caps [CARRIAGE OUT]
Cleaning the wiper and ink caps [CARRIAGE OUT]
The ink caps prevent the nozzles in the heads from drying and thus being clogged.
The wiper wipes off the ink adhering to the surface of nozzles.
As the printer is used, the wiper and ink caps gradually become stained with ink and dust.
If nozzle missing cannot be corrected even after executing the CLEANING function (Refer to “If the
printed pattern is abnormal (Cleaning) (p.3-29)” ) , use Cleaning kit and cotton swab.
T
You are recommend to perform cleaning frequently in order to maintain a high image quality and keep the
printer in good condition.
STEPS:
1Make sure that the printer is in LOCAL mode.
If it is in REMOTE mode, press the [REMOTE] key.
2Press the [ST.MAINT] key and press the [ENTER] key.
When [CARRIAGE OUT] is displayed, press the [ENTER] key. Then the carriage moves to above the platen.
Tools necessary for cleaning.
When solvent ink is used
When water-based ink / sublimation
transfer ink Sb51 is used
Cleaning solution (SPC-0369) Cleaning Liquid Bottle Kit A29 (SPC-0137)
Goggle Goggle
When cleaning the ink station or heads, be sure to wear supplied gloves (When
solvent ink is used) and goggle . If you do not use the goggle, you may get ink
in your eyes.
Do not move the carriage out of the capping station by hand.
Follow the following procedure to move the carriage.
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
ST.MAINTENANCE
CARRIAGE OUT <ent>
To Next Page
Loading...
