4-9
Cleaning the wiper and ink caps [CARRIAGE OUT]
6After cleaning the wiper, install it in position by holding the projections at both ends.
Be careful of the direction of the wiper.
7Wipe off ink or dirt adhering to the rubbers of the caps and the wiper cover using a
cotton swab dampened with the cleaning solution.
Be careful not to leave lint of the cotton swab. Lint may cause printing failure.
8Close the maintenance cover, and press the [ENTER] key.
After performing the initial operation, the printer returns to LOCAL mode.
Ink cap
ST.MAINTENANCE
COMPLETED :end
∗Being Initialized∗
PLEASE WAIT
To Next Page
Loading...
