4 Daily Maintenance
4-12
8Fill the caps with the cleaning solution using a dropper.
9Close the maintenance cover and press the [ENTER] key.
10Set the time to wait using the [] or [] key.
Normally set 1 minute.
11Press the [ENTER] key.
The carriage returns to the station. The nozzles are capped and the display shown below continues for the set
waiting time during which suction of cleaning liquid and cleaning are performed.
On the lapse of the set waiting time, the printer performs the initial operation and returns to LOCAL mode.
Ink cap
Fill a cap with
washing liquid fully
Fill the liquid.
COMPLETED(NEXT) : ent
Input leaving time.
1 - 99 min
ST.MAINTENANCE
LEAVING TIME : 1 min
Input range:
1 to 99 minutes
(In steps of 1 minute)
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
More than 20 seconds remaining
During The PostProc
PLEASE WAIT
ST.MAINTENANCE
01:00
Less than 20 seconds remaining
During The PostProc
PLEASE WAIT
ST.MAINTENANCE
∗ ∗ ∗ ∗ ∗ ∗ ∗ − − − − − − − − − − −
∗Being Initialized∗
PLEASE WAIT
To Next Page
Loading...
