4 Daily Maintenance
4-16
4Pull out the wiper by holding the projections at both ends.
5Remove the ink from the wiper and the bracket using a cotton swab dampened with
the cleaning solution.
6After cleaning the wiper, install it in position by holding the projections at both ends.
Be careful of the direction of the wiper.
7Press the [ENTER] key.
Replace the wiper with a new one if it is badly soiled or curled. To replace the
wiper, terminate the work instructed here first and then follow the wiper
replacement procedure.(See 4-47)
Clean a wiper and
bracket.
WIPER CLEANING
COMPLETED(NEXT) : ent
To Next Page
Loading...
