5 In Case of Trouble
5-8
7When the display shown below appears, set the cleaning liquid cartridge in the ink
station.
Cleaning liquid is drawn up.
8When the display shown below appears, remove the cleaning liquid cartridge from
the ink station.
The cleaning liquid drawn up is discharged to the waste ink tank.
9On completion of one washing process, the display shown below appears.
If the heads are to be washed again, return to step 5 by pressing the [] key.
To terminate washing, press the [] key.
The display changes as shown below when all steps have been completed.
10Press the [] key when this function is to be terminated without discharging the
cleaning solution.
Press the [] key when this function is to be terminated after discharging the clean-
ing solution.
If the washing procedure is to be terminated, press the [] key to go to step 12.
It is being absorbed
PLEASE WAIT
00:40
Set all washing
liquid cartridges.
1234 5678 9ABC DEFG
Set
More than 20 seconds remaining
Less than 20 seconds remaining
It is being absorbed
PLEASE WAIT
∗ ∗ ∗ ∗ ∗ ∗ ∗ − − − − − − − − − − −
It'sBeingDischarged.
PLEASE WAIT
00:40
Remove all washing
liquid cartridges.
1234 5678 9ABC DEFG
Remove
More than 20 seconds remaining
Less than 20 seconds remaining
It'sBeingDischarged.
PLEASE WAIT
∗ ∗ ∗ ∗ ∗ ∗ ∗ − − − − − − − − − − −
Please select according
to situation.
COMPLETED < > W A S H
Do you discharge a
mainte.Wash.liquid ?
No < > Yes
To Next Page
Loading...
