MIMAKI JV5-160S - Page 191

5-21
Troubles for which error messages are displayed
∗∗∗∗∗ ERROR 58 ∗∗∗∗∗
POSITION ENCODER:DIR
An error occurred in the control sys-
tem.
Turn off the power to the printer and
turn it on after a while. If the same
error message appears again, contact
your local distributor to call for ser-
vice.
∗∗∗∗∗ ERROR 58 ∗∗∗∗∗
POSITION ENCODER:CNT
An error occurred in the control sys-
tem.
∗∗∗∗∗ ERROR 59 ∗∗∗∗∗
CUTTER ENCODER
An error occurred in the control sys-
tem.
∗∗∗∗∗ ERROR 64 ∗∗∗∗∗
TAKE-UP VOLTAGE
An error occurred in the control sys-
tem.
∗∗∗∗∗ ERROR 64 ∗∗∗∗∗
FEEDER VOLTAGE
An error occurred in the control sys-
tem.
∗∗∗∗ ERROR 116 ∗∗∗∗
NCU I/F 00
An error occurred in the control sys-
tem.
Operation can be resumed after turning
off the nozzle missing detection func-
tion.
Turn off the power to the printer and
turn it on after a while.
If the error occurs frequently, contact
your local distributor to call for ser-
vice.
∗∗∗∗ ERROR 116 ∗∗∗∗
NCU I/F 01
An error occurred in the control sys-
tem.
∗∗∗∗ ERROR 120 ∗∗∗∗
ENVIRONMENT TEMP(LO)
The ambient temperature is outside the
permissible temperature range (too
low).
Adjust the ambient temperature of the
printer.
To continue operation without chang-
ing the ambient conditions, press the
[ENTER] key.
∗∗∗∗ ERROR 121 ∗∗∗∗
ENVIRONMENT TEMP(HI)
The ambient temperature is outside the
permissible temperature range (too
high).
∗∗∗∗ ERROR 134 ∗∗∗∗
MEDIA ENCODER:SENSOR
An error occurred in detection by the
media encoder.
(Counting impossible)
Select “NORMAL” in [MediaFeed
SETUP] - [FEED METHOD] or turn
off the power to the printer and turn it
on after a while.
If the same error message appears
again, contact your local distributor to
call for service.
∗∗∗∗ ERROR 134 ∗∗∗∗
MEDIA ENCODER:DIR.
An error occurred in detection by the
media encoder.
(Wrong orientation)
∗∗∗∗ ERROR 134 ∗∗∗∗
MEDIA ENCODER:ORIGIN
An error occurred in detection by the
media encoder.
(Origin detection impossible)
∗∗∗∗ ERROR 135 ∗∗∗∗
MEDIA FEED UNUSUAL
An error occurred in media feed. Check that the media has been set
properly.
Using [SET UP] - [MediaFeed
SETUP] - [MOVEMENT TEST], per-
form testing to see if the media is com-
patible with direct feed.
If the error status is not cleared even
with a proper media, select “NOR-
MAL” in [SET UP] - [MediaFeed
SETUP] - [FEED METHOD] or turn
off the power to the printer and turn it
on after a while.
If the same error message appears
again, contact your local distributor to
call for service.
Error message Cause Remedy