2 Before Use
2-32
MACHINE SET functions
Function name Sub function Setting value Function
DRYNESS FAN STOP TIME 0 to 240 Min, CONTINUE Movement setting of the drying fan
is performed.
[STOP TIMER] sets the time from
the completion of the printing to the
stopping of the rotation of the fan.
[RENEW] switches over the current
status of the fan
RENEW ON, OFF
DRYNESS FEED (p. 6-18) ON, OFF Change the feed operation after
printing.
CONFIRM. FEED
(p. 6-18)
ON, OFF Set whether or not to perform feed-
ing the media after test printing for
checking of the printing result.
BACK FEED ON, OFF
MEDIA CUT
(p. 6-19)
ON MOVE. DROP
MEDIA
ON, OFF Allocate [>] key to DIRECT CUT
key of MEDIA CUT.
When [MEDIA DROP] key is OFF,
the media dropping movement is not
performed.
OFF
TIME SET (p. 6-19) ON, OFF Set the date and time on the printer.
UNIT SETUP
(p. 6-19)
TEMP. °C or °F Change the units of temperature,
length and area to be used with the
printer.
LENGTH mm or inch
STAMP SETUP (p. 6-20) ON, OFF Make settings for outputting the date
and time and printing conditions
after printing.
Detection of media thickness (p. 6-21) AUTO, MANUAL Set how to detect media thickness
performed prior to the detection of
media width.
MACHINE NAME (p. 6-21) 01 to 99 When the printer is connected
through the USB 2.0 interface to a
system to which two or more
machines are connected, set the
identifier of the printer to have the
system recognize it.
To Next Page
Loading...
