MIMAKI JV5-160S - Turning the Power On

3-3
Turning the power on
Turning the power on
Turn the power on.
STEPS:
1Turn on the power to the printer.
Press the power switch located on the front of the printer once.
When the power is turned on, the LCD panel displays [BOOT] first and then displays the firmware version
number.
2The message [PLEASE WAIT] appears flashing.
The printer performs initial operation.
3The printer enters the LOCAL mode.
If media has been set on the printer, the media select display appears.
4On making sure that the display shown below has appeared, turn on the power to the
computer that is connected to the printer.
 Make sure that the front cover and maintenance covers are all closed. If any of
the covers is open, the printer does not start up properly.
BOOT
∗Being Initialized∗
NOT POW-OFF !!
JV5-160S(S) V ∗.∗∗
PLEASE WAIT
L. ∗ > [JV5-01]
MEDIA SELECT
ROLL < > LEAF