3 Printing
3-10
3Set the left end of the core of the roll media on the let roll holder.
Push the roll media onto the roll holder until the roll core is all the way seated.
4Loosen the screw for the right roll holder, and insert the right roll holder into the core
of the roll media.
Make sure that the roll holder is in a proper position, and tighten the roll holder securing screw.
5At the rear of the printer, unroll the roll media by such a length that the unrolled part
is long enough to reach the front end of the platen.
The roll media can be set easily if you handle it while supporting it with the
media support bar.
Media support bar
To Next Page
Loading...
