MIMAKI JV5-160S - Page 83

3-15
Setting the media on the printer
When the media thickness cannot be detected
There may be a case where the media thickness cannot be detected properly depending on the media.
In such a case, the media thickness must be input manually.
STEPS:
1An error is displayed, and the carriage returns to the station.
2Input a value of the media thickness using the [] or [] key and press the [ENTER]
key.
Initial value: 0.1 mm; Input range: 0.1 mm to 1.0 mm
3Press the [] key twice to select ROLL. (Press the [] key twice to select LEAF.)
The carriage moves and detects the media width.
Thickness detection is also performed here if the [END] key is pressed at step 2 above.
When [ThicknessDETECT] of [MACHINE SET] function has been set to
MANUAL
The detected thickness of the media is always input manually.
Even if the same media is used, when the thickness is different, it is convenient to set to MANUAL.
STEPS:
1Select [Roll]
2Input a value of the media thickness using the [] or [] key and press the [ENTER]
key.
Initial value: 0.1 mm; Input range: 0.1 mm to 1.0 mm
3The carriage moves and detects the media width.
∗∗∗∗∗ ERROR 50 ∗∗∗∗∗
THICKNESS DETECT
The thickness of the
media is inputted.
(range : 0.1 - 1.0 mm)
thickness = 0.1 mm
MEDIA SELECT
ROLL < > LEAF
The thickness of the
media is inputted.
(range : 0.1 - 1.0 mm)
thickness = 0.1 mm