vii
Selecting and checking printing conditions..............................................3-20
How to select a user type.......................................................................3-20
How to check the user type....................................................................3-20
Operating the heaters ..................................................................................3-21
Turning on the power to the heaters......................................................3-21
Checking the preset temperature and setting a temperature
during printing ........................................................................................3-22
What is beading ? (When solvent ink is used).......................................3-23
Temperature adjustment (When solvent ink is used).............................3-24
In case of heater trouble ........................................................................3-25
Setting the reference value for dot misalignment correction ..................3-26
Checking for nozzle clogging, and unclogging nozzles...........................3-28
Printing a test pattern (test printing).......................................................3-28
Relationship between head row and test pattern...................................3-29
If the printed pattern is abnormal (Cleaning)..........................................3-29
If nozzles cannot be unclogged [FILL UP INK] ......................................3-31
Correcting the media feed rate [MEDIA COMP.]........................................3-33
If dots are not in alignment [DROP.POScorrect].......................................3-35
Effective Plotting Area.................................................................................3-37
Establishing the Origin................................................................................3-38
Printing an image .........................................................................................3-39
Starting the printing operation................................................................3-39
Interrupting the printing operation..........................................................3-40
Cutting the media after completion of printing .......................................3-41
Automatic cleaning.................................................................................3-43
Maintenance while Printing (When sublimation transfer ink Sb51 is used)
...............................................................................................................3-45
Display of [INK NEAR END] or [INK END] ..................................................3-48
Indication of remaining amount of ink for each cartridge .......................3-48
Turning the power off...................................................................................3-51
To Next Page
Loading...
