3 Printing
3-30
4Select a cleaning method using the [] or [] key.
5Press the [ENTER] key.
Cleaning starts.
The second line of the lower LCD shows the progress of the operation as increase in the number of * marks .
On completion of cleaning, the printer returns to LOCAL mode.
6Perform test printing again, and check the result. (See 3-28)
Repeat steps 1 to 5 until normal printing result is obtained.
NORMAL Select this if any line is missing.
SOFT Select this if any line is bent.
HARD Select this if inferior printing cannot be improved even by [NORMAL] or [SOFT] cleaning.
If there is a problem with the waste ink tank, the display will show either of the
following messages.
Follow the displayed instructions to restore the normal conditions.
If a normal print of the test pattern cannot be obtained even after executing the
cleaning function above, clean the wiper and ink caps. (Refer to “Cleaning the
wiper and ink caps [CARRIAGE OUT] (p.4-7)” )
CLEANING
TYPE : NORMAL
Type:
NORMAL
SOFT
HARD
CLEANING ACTIVE
00:40
More than 20 seconds remaining
Less than 20 seconds remaining
CLEANING ACTIVE
∗ ∗ ∗ ∗ ∗ ∗ ∗ − − − − − − − − − − −
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
No waste ink tank,
or a tank is FULL.
<ENT>keyHIT is after
theTANK set or exchg
Replace a
waste ink tank.
<ENT>keyHIT is after
the TANK exchange.
∗∗ TEST DRAW ∗∗TEST DRAW
<ENT>
To Next Page
Loading...
