Minebea Intec Signum 3 Ex - Page 50

50
Signum 3 Ex
Example:
Determining the number of uncounted parts�
Settings (dierent from the factory settings):
Setup: Application 1: Counting
Setup: Device Parameters: Printout: PRTPROT: 7�6
then select the menu line items of your choice (see “Conguration” for options)
1�) Place empty container on the
platform�
)
2�) Tare the scale�
Note: If the automatic tare
function is enabled, you do
not need to press the ) key
to tare the platform; the tare
weight is saved automatically
when you place the container
on the platform�
3�) Place a number of parts in the
container for the reference
quantity (in this example,
20pcs)�
20
4�) Enter the number of parts
using the keypad or
using r :
1, 2, 5, 10, 20, etc�
r
5�) Start calculation of the
reference sample weight
Set the number of reference
parts using r: 1, 2, 5, 10,
20, etc�
Start the reference sample
weight calculation using the
O key�
If the weight is too light,
reduce the minimum load
setting or increase the
reference sample quantity
setting in the main display
Inf 29 and the number of
parts in the container�
6�) Add a quantity of uncounted
parts to the container
Read the result
Opt is displayed if automatic
reference sample updating is
enabled�
p
7�) Print the results
nRef + 38 pcs see:
Conguring Printouts
wRef + 0.003280 kg
G# + 0.373 kg
T + 0.248 kg
N + 0.125 kg
Qnt 38 pcs
--------------------
Counting Application Z
Neutral Measurement Application Z nM