Mirae Mx200 - CHAPTER 3 Precautions for Production

3
Is the tension of stripped
off vinyl appropriate?
Set the appropriate
tension of vinyl.
If the tension is too low
The vinyl may pass the vinyl off
position and move with the reel. In
this case, feeding is performed but the
nozzle cannot fetch the chips, and the
error message is displayed. If this
error occurs, remove the feeder, set
the feeder to the setting jig, raise the
reel cover, take out the vinyl to the
rear, and reinstall the feeder.
4
Is the nozzle appropriate?
Refer to the equipment manual or
contact CS for details.
5
Is the pickup parameter
appropriate?
6
Is the part DB
appropriate?
Precautions for
Production
Contents
ROUTINE INSPECTION POINT
AND TIP FOR
PRODUCTION..........................2
PRECAUTIONS IN USING
MODIFIED
FEEDER............................................
........4
ROUTINE INSPECTION ITEMS
AND
METHOD...........................................
..........5