In standby mode, and number input mode
• A short press on a key enter the digits “0” - “9” and the characters * and #.
• A long press on the "0" key adds a "+" to the number.
• Enter a pause in number input mode by a long press on the # -key. A pause is indicated
by a "P" in the display.
• A long press on the * - key changes the tone sender on.
Tone sender on is indicated by a "T" in the display.
• The keys "0", "2" - "9" can be used for speed dialing. Press and hold any of the keys to
access a contact beginning with a specific letter. For example, to access a contact beginning
with the letter "A", press and hold the key "2" and then press "Call" to speed dial.
In text input mode
• A short press on a key 0-9, displays the first available character on that specific key. The
marked character is selected after a timeout, or when another key is pressed.
• To change to upper/lower case, press the * -key before entering the character.
The *-key can also be used to display only the digits.
• To add space in the text, make a short press on key 0.
• The first character entered when adding/editing a name in the Contacts menu, will be an
upper level character followed by lower level characters, unless the * -key is pressed before
entering the character. To switch between Abc, ABC, abc, and 123 the *-key is pressed.
• A long press on the #-key displays special characters.
• A long press on the *-key opens a menu to change writing language (Default follows the
menu language setting).
ACCESSORIES
BELT CLIPS
Two belt clip options are available:
• Hinge-type clip (standard)
The clip on the back of the handset is used to fasten the handset to a belt or similar. A
swivel-type clip may also be used.
• Swivel-type clip
The ordinary belt clip can be replaced with a special swivel-type belt clip adapted to firmly
place your handset onto your belt.
SECURITY CORD
The security cord is 800 mm long. The security cord is attached directly to the handset.
To Next Page
Loading...
