Mitel 5613 DECT Phone User Guide for MiVB
To set the screen saver:
1. Select “Display” from the handset menu.
2. Select “Screen saver”. The current setting is displayed under "Screen saver".
3. Select “Information”, “Black”, or “Black also in call”.
4. Press "Select".
5. Press "Back".
Brightness
1. Select “Display” from the handset menu.
2. Select “Brightness”. The current setting is displayed under "Brightness".
3. Select “Normal” or “Power save”.
4. Press "Select".
5. Press "Back".
TIME & DATE SETTINGS
The time and date displayed in the handset cannot be changed by the user. The DECT system
is solely responsible for keeping the time. The handset also synchronises with the DECT system
time when:
• The handset is turned on after having been turned off. The handset requests the current
DECT system date and time.
• The handset remains on for longer than 24 hours. The handset requests the DECT system
time every 24 hours from the time it was last turned on.
The time and date formats displayed in the handset can be changed by the user as described
in the following sections.
Set Time Format
1. Select "Time & Date"
2. Press "Select".
3. Select time format. The actual time format will be displayed. Selectable time formats:
• hh:mm (am/pm) (for example: 1:00pm)
• hh:mm (for example 13:00)
4. Press "Select" to save the setting.
Note:
1. When charging the handset in a DP1 Desktop Programmer or CR3 Charging Rack,
information is replaced by the large license indicator shield. When in the desktop
charger it is the same as when out of the charger.
2. When the handset with the screen saver set to "Information" is in a charger, the
Owner ID is displayed even if the handset switched off. This simplifies identification
when many handsets are in a charging rack
To Next Page
Loading...
