Mitel 5613 DECT Phone User Manual for MiVB
The easy replacement procedure is done via the handset display and the DC4 Advanced
Desktop Charger or the CR3 Charging Rack.
The following settings are replaced during easy replacement:
• DECT registration
• User parameters (including User ID)
• Contacts
• The extension number is assigned to the new handset.
The following settings are not replaced during the easy replacement:
• Call list
BEFORE STARTING EASY REPLACEMENT PROCEDURE
1. Check that both the old handset (that is, the handset to be replaced) and the new handset
(that is, the replacement handset) are of the same device type (d43).
2. Check that the software of DC4 Advanced Desktop Charger or CR3 Charging Rack is of
version 1.3.x or greater by using the WinPDM. Refer to the Configuration Manual for the
handset; see Related Documents on page 74.
3. Make sure that the handset batteries are charged before starting the easy replacement
procedure.
4. Switch off the new handset by long pressing .
EASY REPLACEMENT PROCEDURE
During the Easy Replacement procedure, the LED indications on the charger can be used to
follow the replacement procedure. For more details, see also LED Indications during Easy
Replacement on page 72.
IMPORTANT: Never remove a handset from the charger until the instructions in the display tells
you to do so. If there is an error indication, it may be allowed to remove the handset,
see Chapter 7 Troubleshooting on page 63 for further instructions.
After the old handset has been in the charger, the new handset needs to be placed in
the charger regardless if the replacement was successful or not. Failing to do so may
result in malfunction and the new handset will need to be sent for service.
To Next Page
Loading...
