Mitel 5613 - Making and Receiving Calls

Mitel 5613 DECT Phone User Manual for MiVB
26
INCOMING CALL
A ring signal and/or a vibrating handset, give you notice of a call. Ring signal and vibrator can be
disabled. The calling party’s handset number or name is shown. The name will be shown if the
calling party’s handset number is stored in Contacts or if calling line information is available.
Press the Off-hook key to answer the call. When a headset is connected to the handset, the
answering button on the headset can be used to answer the call.
Other answering methods can also be set in the Settings menu, see Settings on page 18. The
answering methods are; "Automatically" and "Loudspeaking".
When “Automatically” is enabled, all incoming calls will be connected automatically.
ANSWER A CALL
When the signal sounds press to answer the call, or press the soft key to answer the call
in loudspeaking mode. The name/number of the calling party is displayed if calling line
information is available.
END A CALL
Press to end the call. The duration of the call is shown in the display. The total time of
the call can also be retrieved from the Calls menu > Call time.
OUTGOING CALL
PRE-DIAL
1. Enter the number.
2. Press or “Call” to get the line. The number is shown on the display while dialing.
If needed, press “Clear” to erase the number. The Navigation key can be used it to step
and add or delete a digit in the middle of a number. The tone sender in a pre-dialed number
can also be turned on by long pressing .
An international number can be dialed from the handset by entering a + character followed
by the country code and local number. To enter the + character, long press the 0 key until
the character is shown in the display.
DIAL A NUMBER FROM THE CALL LIST
1. Press when in idle mode; or press “Menu”, select “Calls” and then select “Call list”.
2. Select a number.
3. Press or “Call” to dial. The number can be edited before the call is started. Press
“More” and select “Edit number”.
DIAL A NUMBER FROM CONTACTS
1. Press the “Menu” Soft key.
2. Select “Contacts”.
3. Select “Call contact”.