Mitel 5613 - Error and Warning Message Interpretation

65
ERROR OR WARNING MESSAGES
DISPLAY SHOWS PROBABLE CAUSE ACTION OR COMMENT
No access The network is in range, but no
access rights.
Switch handset off and then
switch it on again or contact
system administrator.
No System. The handset
beeps once a minute
(during max 30 minutes)
with a low tone followed
by a high tone (if
enabled, the vibrator
also follows the beeps).
The handset is out of coverage or
handset is defective.
Stop the beep with the Sound off
key and go into range.
Note: When re-entering the
coverage area it can take a
couple of minutes before the
handset automatically has
registered into the system.
or
contact system administrator.
SERVICE NEEDED
Parameters corrupt
Note: This display
message is only shown
in English.
The handset is defective. Send the handset for service.
SERVICE NEEDED
Invalid IPDI
Note: This display
message is only shown
in English.
Easy replacement procedure not
followed correctly or failure during
easy replacement procedure.
Send the handset for service.
Enter PIN code The handset’s lock is activated. Enter the required PIN code. If
PIN code lost enter new via
WinPDM or do a factory reset via
WinPDM.
Battery low, charge now The battery level is low. Charge or replace the battery.
Phonebook is not
available at the moment.
The phonebook does not respond,
not available at the moment.
Try again later or if fault persists
do a factory reset via admin
menu or WinPDM.
Voice mail number not
defined
There is no Voice mail number
defined in the handset.
Define a Voice mail number via
WinPDM.
Could not encrypt
connection
The parameter "Encryption
Required" is enabled in the handset
in combination with;
1) Unencrypted base station(s);
and/or,
2) Unsupported base station(s).
1) Disable the "Encryption
Required" parameter in handset;
and/or,
2) Enable the encryption in the
base station(s); and/or,
3) Use supported base station(s).
Ask your supplier.