Mitel 5613 DECT Phone User Manual for MiVB
CONFERENCE CALL
Prerequisite, a new call has been started during conversation, see Start a New Call during
Conversation on page 28.
By initiating a conference call, an conversation can be made between several participants
simultaneously.
1. Press the "More" soft key.
2. Select "Conference call"
1
.
3. Press "Select".
The person initiating the conference call is the conference leader, and the others are participant
members of the conference call.
CALL BACK
When a call is made to a busy handset, it is possible to automatically call back when the busy
handset is free. When a busy tone sounds, do as follows:
1. Press the "More" soft key during the call.
2. Select "Call back"
1
.
3. Press "Select".
4. Press and wait until the handset alerts.
5. When the handset alerts, press and the call will automatically be started.
SEND CALL WAITING
This feature sends a notification tone to an engaged handset to announce to the engaged party
that another caller is trying to reach them. To notify an engaged party:
1. Press the "More" soft key.
2. Select "Call waiting"
1
.
3. Press "Select". The other part will get a "Call waiting" signal.
When the line is free it will automatically call the number again. This is system dependent.
ANSWERING CALL WAITING
Depending on system setup and configuration, this feature might be handled in one of two
different ways:
Method 1
During an ongoing conversation and a short tone for another incoming call appears, do as
follows:
1. Press the soft key "More" during the call.
1. Only visible if defined in WinPDM.
To Next Page
Loading...
