3. Adjust the volume by pressing up and down on the navigation key.
4. Press "Back" to save the setting.
Select Ring Signals
1. Select "Ring signals".
2. Select "Internal call", "External Call", or "Callback"
1
.
3. Press "Select".
4. Select ring signal. The selected ring signal can be reviewed by pressing the "Play" soft key.
The ring signal is repeated until the "Stop" soft key is pressed.
5. Press "Select".
Turn the Vibrator on or off
1. Select “Vibrator alert”.
2. Select “On”, “On if silent” (i.e. the vibrator is on when the handset is muted), or “Off”.
3. Press "Select".
4. Press "Back" to save the setting.
Set the Key Sound
This means that every time a key is used, a low sound is heard.
1. Select “Key sound”.
2. Select “Silent, “Click”, or “Tone”.
3. Press "Back".
The key sound can be reviewed by pressing the "Play" soft key.
SELECT HEADSET PROFILE
1. Select "Headset".
2. Select "Mic on boom", "Mic on cable", or "Customized headset profile"
2
3. Press "Select".
DISPLAY SETTINGS
Screen Saver
The screen saver can be set to one of the following settings:
• Information: Displays status and identification information while the handset is idle.
• Black: The screen is black when the handset is idle.
• Black also in call: The screen is also black when the handset is in call.
1. "Callback" is only applicable if defined in the WinPDM/Device Manager. See also Call Back on page 30 for more
information.
2. "Customized headset profile" is only visible if the headset profile has been configured in the WinPDM/Device Manager.
To Next Page
Loading...
