26/1531-ANF 901 14 Uen S 2019-10-18 12
H
OW TO START A NEW PHONE
7.2 CONNECTING THE PHONE TO A NETWORK
To be able to connect the phone to a network, the following parameters must be config-
ured:
• The phone's IP address, subnet mask, and default gateway.
When using DHCP, these parameters are configured automatically.
• The IP address of the software server.
This address is configured automatically using DHCP, or manually from the
phone. If DHCP is used for providing this parameter, the DHCP server must be
configured before the phones can connect to the network. For information on
how to configure the DHCP server for providing the phone with the IP address to
the software server, see 18.1 Data from DHCP on page 63.
• The IP address of the SIP proxy / SIP registrar.
This address is configured using the configuration file or manually from the
phone. For information on how to configure the phone with the IP address of the
SIP proxy / registrar see 11.9 Setting the IP Address of the SIP proxy / registrar
on page 26
7.3 SIP REGISTRATION
7.3.1 GENERAL
The necessary settings in the configuration files for this are created automatically when
using MX-ONE Service Node Manager. In the configuration file aastra.cfg/startup.cfg
the following parameters are set:
dynamic sip:1
sip line1 user name: “Not configured” *)
sip proxy ip: 192.168.10.10
sip proxy port: 5060
sip registrar ip: 0.0.0.0 **)
sip registrar port: 5060
*) this line is used in the case of emergency calls when the telephone is not registered.
It is also used in the case of register with the *11 procedure.
**) shall be set to 0.0.0.0 because the system will replace the zeros with the actual IP
address to the registrar as a part of the registration process of Logon XML key, VDP
Login key or *11 procedure.
The extension_profile --ext-serv D30 is set to 1 if a user is not allowed to logoff. This
setting will control whether Logoff key is pushed out to the phone and whether the #11
procedure to LOGOFF is accepted. This setting has no effect for VDP Login as this is
a native phone function.
7.3.2 LOG ON/LOG OFF [XML KEY]
In aastra.cfg/startup.cfg, “action uri startup” will enable the prompt to logon at phone
boot:
action uri startup: http://$$PROXYURL$$:22222/Startup?user=SIPUSER-
NAME$$
To Next Page
Loading...
