Mitel 6900 - RESTART; RESTORE; RESTORE TO FACTORY DEFAULT

MITEL 6900, 6970, 6800, AND 6700 SIP TERMINALS FOR MIVOICE MX-ONE
19 26/1531-ANF 901 14 Uen S 2019-10-18
9 RESTART / RESTORE
There are three options:
• Restart the phone. Can be used when settings shall be applied.
• Remove local configuration settings. The settings that are done from the phone
UI and web UI are lost.
• Restore to factory default. The phone gets the same data as when leaving the
factory and removes any saved directory files.
9.1 RESTART
Phone UI
• Press the Options key
• Scroll down and select Restart Phone
Web UI
• Log in to the web interface. Operation > Reset > Restart Phone
9.2 REMOVE LOCAL CONFIGURATION SETTINGS
All configuration made on the phone, via Web UI or configured by MX-ONE at logon is
stored as local configuration in the phone. By removing the local configuration the
administrator can ensure that phone is configured according to configuration files only.
Phone UI
• Press the Options > Administrators Menu > Erase Local Config
Restart the phone.
6739; Press Options > Advanced (log in as administrator) > Reset > Erase
Local Config.
Web UI
• Log in to the web interface. Click on Operation > Reset > Remove Local
Configuration Settings.
Restart the phone.
It is also possible to remove the local configuration settings for registered terminals, by
entering the following command from MX-ONE:
extension_unregistration with parameter reset
9.3 RESTORE TO FACTORY DEFAULT
Factory default reset will force the phone to go back to the initial setting. If configuration
server is not set via dhcp options, you will need to set it again. If the configuration server
shall be accessed via https, only the commercial root CAs (Verisign etc) are preloaded.
Phone UI
• Options > Administrators Menu > Factory Default