26/1531-ANF 901 14 Uen S 2019-10-18 22
C
ONFIGURING THE PHONE
11 CONFIGURING THE PHONE
This chapter describes how to configure the phone from the phone menus as an admin-
istrator.
This chapter also covers the configuration via the configuration files,
aastra.cfg/startup.cfg,, <model>.cfg or <mac>.cfg.
The parameters can be set in any of these configuration files, but in this section it is the
recommended placing that is described. If one parameter occurs in several configura-
tion files, it is always the last read parameter value that the telephone uses.
11.1 SETTINGS MODE
To enter into settings mode in the phone user interface:
1. For 6700 terminals, press , Options key or for 6900/6800 terminals,
press , Options key.
To enter the web user interface:
1. Find the IP address of the telephone by selecting Options > Phone Status > IP
& MAC Addresses
2. Enter the IP address to the telephone into the address field in the web browser
in the PC and press enter.
3. To log in to the end user page, see 12.2 Web Interface Passwords for End Users
on page 56
4. To log in to administrator page, see 10 Entering Administrator Mode on page 21.
11.2 SETTINGS IN THE CONFIGURATION FILE
AASTRA.CFG/STARTUP.CFG
The necessary settings in the configuration file for getting the telephones to work in a
correct way with MX-ONE are created automatically when using MX-ONE Service
Node Manager. In the configuration file aastra.cfg/startup.cfg the parameters must
have the following values:
! sip aastra id: 1
! sip send line: 1
! sip xml notify event: 1
! sip pai: 1
! directed call pickup: 1
! directed call pickup prefix: Pickup
! collapsed context user softkey screen:1
softkey selection list:mobile, none, speeddial, line, xml, speeddialxfer, speed-
dialconf, phonelock, empty”*)
*) the options for the softkeys that are working with MX-ONE and is presented in the web UI.
To Next Page
Loading...
