Mitel 6900 - INITIATING DATA FROM MX-ONE PROVISIONING MANAGER

26/1531-ANF 901 14 Uen S 2019-10-18 44
C
ONFIGURING THE PHONE
placed. The LED of the shortcut key will indicate the status of such a diversion or
deflection.
Diversion monitoring keys are configured from the PBX.
To get the DMN key working, some parameters in the configuration file have to be
enabled, see section 11.2 Settings in the configuration file aastra.cfg/startup.cfg on
page 22.
It is possible to change the type of ring signal (periodic, muted, visual only etc.) for the
DMN key and it is changed from the PBX or from MX-ONE Provisioning Manager. The
default value is visual only. No settings for this can be done in the aastra.cfg/startup.cfg
file.
It is also possible to set a pop-up option for monitoring keys. With this feature enabled,
the page containing a monitor key is displayed when a call to the associated monitored
extension is received.
This feature is enabled in the aasta.cfg file: blf activity page switch:3
There are the following options:
• 0: Page switching disabled. Default value.
• 1: Switch page when the monitored extension receives a call.
• 2: Switch page when the monitored extension receives a call or put the call on
hold.
• 3. Switch page when the monitored extension receives a call or put the call on
hold or when the monitored extension change to speech state.
To avoid too much flashing of switching pages, all the DMN (and MNS) keys should be
collected on one page.
11.14 INITIATING DATA FROM MX-ONE PROVISIONING
MANAGER
MX-ONE Provisioning Manager (PM) is used to set data e.g. for MNS, TNS, DMN, MCT
and PEN into the phones from MX-ONE. PM can be used by system administrators and
by end-users. The screenshots below shows the menu in MX-ONE Provisioning
Manager for setting data on the softkeys in 6757 terminal.