Mitel 6900 - ENABLING; DISABLING DHCP; SETTING THE PHONES IP ADDRESS; SETTING THE IP ADDRESS TO THE DEFAULT GATEWAY; SETTING THE IP ADDRESS AND DOWNLOAD PROTOCOL OF THE SOFTWARE SERVER

MITEL 6900, 6970, 6800, AND 6700 SIP TERMINALS FOR MIVOICE MX-ONE
25 26/1531-ANF 901 14 Uen S 2019-10-18
where the time (parameter lldp startinterval) is changed to match the time in the LAN
switch at ordinary operation for example 32 seconds. When the phones are started, the
timer shall be changed back to the original value in the LAN switch.
The example below shows which parameters to set in aastra.cfg/startup.cfg:
# LLDP enabled = default
lldp: 1
# LLDP update interval 30 s
lldp interval: 30
# Controls the LLDP start interval, 32 s
lldp startinterval: 32
The parameter lldp startinterval is only valid during the phone bootup process and it will
control the LLDP time-out interval where the phone sends LLDP advertisements and
listens for the LLDP responses from the switch before proceeding to the DHCP stage.
The default value of this parameter is 32 seconds.
For more detailed information see Administrator Guides for Mitel Models 6900, 6970,
6800, 6700 and 9000 Series IP SIP Phones.
11.5 ENABLING / DISABLING DHCP
Follow the steps below to enable or disable DHCP:
Options > Admin Menu[6739i; select Advanced] > Network Settings > DHCP
Settings > DHCP
11.6 SETTING THE PHONE'S IP ADDRESS
If DHCP is used, the phone's IP address is set automatically, using the DHCP server.
To be able to set the phone's IP address manually, DHCP must first be disabled on the
phone, see 11.5 Enabling / Disabling DHCP on page 25.
Options > Admin Menu [6739i; select Advanced]> Network Settings > IP Address
11.7 SETTING THE IP ADDRESS TO THE DEFAULT GATEWAY
If DHCP is used, the IP address to the default gateway is set automatically, using the
DHCP server. To be able to set the IP address to the default gateway manually, DHCP
must first be disabled on the phone, see11.5 Enabling / Disabling DHCP on page 25.
Options > Admin Menu[6739i; select Advanced] > Network Settings > Gateway
11.8 SETTING THE IP ADDRESS AND DOWNLOAD PROTOCOL
OF THE SOFTWARE SERVER
To download the phone software and configuration files, the phone must be configured
with the type of protocol and IP address matching the software server (configuration
server). The configuration server can be set using these alternatives:
• Manually from the phone UI; Options > Admin Menu > [6739i; select
Advanced]> Configuration Server.