Mitel 6900 - CONNECT EXISTING CONFIGURATION FILE TO MX-ONE SERVICE NODE MANAGER; RETRIEVE THE BACK-UP COPY

MITEL 6900, 6970, 6800, AND 6700 SIP TERMINALS FOR MIVOICE MX-ONE
9 26/1531-ANF 901 14 Uen S 2019-10-18
6.4 CONNECT EXISTING CONFIGURATION FILE TO MX-ONE
SERVICE NODE MANAGER
In a system where MX-ONE Service Node Manager has not previously been used
when working with an IP phone configuration file, the existing configuration file can be
connected to the MX-ONE Service Node Manager instead of having to be recreated.
Follow the steps below to connect a configuration file to MX-ONE Service Node
Manager.
1. Log on to MX-ONE Service Node Manager.
2. Go to Telephony > IP Phone > SW Server where you register the IP Phone SW
Server.
3. Go to Telephony > IP Phone > Connect Configuration File.
4. Select the IP Phone SW Server and search for existing files. Click on the
Connect icon next to the configuration file to connect to.
5. Go to the Configuration File task. Select the connected configuration file and
use the Change icon to view/edit the file, if needed. When the adaptation of the
file is completed, it is automatically stored under the correct directory in the IP
Phone Software Server.
6. For the phones that are already registered to the PBX, select the Unregistration
option to force the phones to fetch the new configuration file.
6.5 RETRIEVE THE BACK-UP COPY
If any problem is discovered when a new configuration file has been loaded into the
phones and there is a need to go back to the previous version, the following procedure
shall be used:
1. Log on to MX-ONE Service Node Manager.
2. Go to Telephony > IP Phone > Configuration File.
3. Use the restore icon.
4. For the phones that are already registered to the PBX, select the Unregistration
option to force the phones to fetch the new configuration file. For phones that
are not registered, 6.1 Create a Configuration File on page 7.