26/1531-ANF 901 14 Uen S 2019-10-18 14
H
OW TO START A NEW PHONE
7.3.4 LOG ON WITH PROCEDURE
This method can be useful for the Mitel 6863 model which does not have a logon key.
Note: This method is not supported for TLS.
The procedure to register the telephone is:
• Enter *11[*PIN]*extension number#. The PIN code must be entered if the PIN
code is initiated in MX-ONE Service Node.
• If the registration is successful, the extension number and the name of the user
is shown in the display.
The procedure to log off the telephone is:
• Enter #11#.
• If the log off is successful, the display shows Logged off.
7.3.5 MAC CONFIGURATION FILE
There are information in the template file for the mac file stored under
/etc/opt/eri_sn/aastraSIPphones.
The MAC configuration shall be used for exceptions to the general key layout chosen
for each model. See Chapter “Default key layout” if the general layout shall be
changed.
Alternative1.
Use MAC file to only logon via the logon prompt at bootup, which is set via “sip action
uri startup” and not configure any logoff key. The terminal can be logged of via
command extension_unregistration --forced. Then it will prompt for logon after the
reboot:
Write protect the logoff keyset.
Example:
Change the logoff key to be a speeddial to call the operator and write protect it by
prefixing with “!”.
!softkey9 type:speeddial
!softkey9 label:Operator
!softkey9 value:09
The Diversion key can also be write protected in the similar way.
As the ‘action uri startup’ is used Free Seating is enabled, which means that the
terminal may be pushed out
Alternative2.
Use the MAC file to explicitly set an extension number:
sip line1 user name:<extension number>
sip line1 auth name:<extension number>
sip line1 password:<PIN code
If the PIN code is changed in MX-ONE, it must also be manually changed in the
<mac>.cfg file.
Inactivate action uri startup (set in aastra.cfg/startup.cfg) by setting it to an empty string
(this will also inactivate Free Seating. The terminal will not be pushed out when
someone logs in using the same extension number on another phone):
action uri startup:””
To Next Page
Loading...
